Subaru Impreza 2003 Service Manual page 1594

AUTOMATIC TRANSMISSION
4) Install the spring and four steel balls to specified
positions of upper valve body.
(A) Steel ball
(B) Spring
5) Align the hole in side plate with the hole in sepa-
rator plate, and then install support plate and upper
separator plate to middle valve body.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
( A )
(A) Upper separator plate
(B) Side plate
6) Insert six steel balls in their proper positions to
middle valve body.
(A) Steel ball
(B) Middle valve body
CONTROL VALVE BODY
( A )
( B )
AT-00074
( B )
AT-00070
( B )
( A )
AT-00069
7) Install three filters to lower valve body.
NOTE:
Pay attention to the location of filters.
( A )
(A) Strainer
(B) Lower valve body
8) Install lower separate plate to lower valve body.
(A) Lower separator plate
(B) Lower valve body
9) Temporarily assemble valve body.
NOTE:
Be careful not to drop the middle valve body and
upper body interior steel ball, or the lower body fil-
ter.
4AT-62
( B )
AT-00075
( A )
( B )
AT-00076
AT-00077