Subaru Impreza 2003 Service Manual page 1854

MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
2) Install the air intake duct and cleaner case.
(Non-turbo model)
<Ref. to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.> and <Ref. to IN(H4SO)-6, INSTALLATION,
Air Intake Duct.>
3) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-11, INSTALLATION, Inter-
cooler.>
4) Connect the battery ground cable to battery.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Install the rear cushion rubber.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
2) Install the rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front and center exhaust pipes. (Non-
turbo model)
Without OBD
<Ref. to EX(H4SOw/oOBD)-7, INSTALLATION,
Front Exhaust Pipe.>
With OBD
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.>
6) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>
7) Install the rear exhaust pipe and muffler.
TRANSMISSION MOUNTING SYSTEM
T 1
T 2
MT-00081
5MT-46
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure the pitching stopper is not bent or dam-
aged. Make sure the rubber is not stiff, cracked, or
otherwise damaged.
2. CROSSMEMBER AND CUSHION RUB-
BER
Make sure the crossmember is not bent or dam-
aged. Make sure the cushion rubber is not stiff,
cracked, or otherwise damaged.