Subaru Impreza 2003 Service Manual page 1968

MANUAL TRANSMISSION AND DIFFERENTIAL
13) Set the ST.
NOTE:
Also Part No. 41099AA010 can be used.
ST 41099AA020 ENGINE SUPPORT
ST
14) Remove the center and rear exhaust pipe and
muffler. <Ref. to EX(H4DOTC)-9, REMOVAL, Cen-
ter Exhaust Pipe.>, <Ref. to EX(H4DOTC)-14, RE-
MOVAL, Rear Exhaust
EX(H4DOTC)-13, REMOVAL, Joint Pipe.>
15) Remove the propeller shaft. <Ref. to DS-15,
REMOVAL, Propeller Shaft.>
16) Remove the front stabilizer bolt.
17) Remove the ball joint of transverse link from
housing.
18) Using the ST, remove the spring pin of front
drive shaft.
ST 398791700 REMOVER
MANUAL TRANSMISSION ASSEMBLY
MT-00459
Pipe.>, <Ref. to
MT-00076
MT-00460
6MT-38
NOTE:
Do not reuse the spring pin.
19) Remove the front drive shaft.
20) Set the transmission jack under the transmis-
sion, then remove the front crossmember and rear
crossmember.
21) Move the transmission to right side, then re-
move the joint COMPL, stay bolt and reverse check
cable.
NOTE:
If the transmission is not moved, the joint COMPL
and stay bolt will contact body and damage may
occur.
(C)
(A)
(B)
(A) Joint COMPL bolt
(B) Stay bolt
(C) Reverse check cable
22) Remove the fixing bolt of engine and transmis-
sion, then remove the transmission from vehicle.
MT-00461
MT-00454
MT-00886