3. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Set the select lever to "N" range.
3) Disconnect negative cable from battery.
4) Lift-up the vehicle.
5) Remove front, center, rear exhaust pipe and
muffler. (Non-turbo model)
SOHC model
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-9, REMOVAL, Center
Exhaust Pipe.>, <Ref. to EX(H4SO)-10, REMOV-
AL, Rear Exhaust Pipe.> and <Ref. to EX(H4SO)-
12, REMOVAL, Muffler.>
SOHC without OBD model
<Ref. to EX(H4SOw/oOBD)-6, REMOVAL, Front
Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)-9,
REMOVAL, Center Exhaust Pipe.>, <Ref. to
EX(H4SOw/oOBD)-10, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H4SOw/oOBD)-11, RE-
MOVAL, Muffler.>
6) Remove the center and rear exhaust pipes and
muffler. (DOHC turbo model)
<Ref. to EX(H4DOTC)-9, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOTC)-14, REMOV-
AL,
Rear
Exhaust
EX(H4DOTC)-15, REMOVAL, Muffler.>
7) Remove the heat shield cover. (If equipped)
SELECT CABLE
Pipe.>
and
<Ref.
AT-00682
8) Remove the snap pin and washer from range se-
lect lever.
(D)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
9) Remove the plate assembly from transmission
case.
( C )
to
(A) Select cable
(B) Plate ASSY
(C) Clamp
10) Disconnect the cable from select lever, and
then remove the cable bracket.
(A) Adjusting nuts
(B) Cable bracket
11) Remove the select cable from plate assembly.
CS-13
CONTROL SYSTEMS
(A)
(B)
(C)
(E)
( A )
( B )
(A)
(B)
CS-00036
CS-00037
CS-00038