9) Check the swing torque of rod in relation to the
gear shift lever.
10) Check that there is no excessive play and that
parts move smoothly.
2. 6MT
NOTE:
• Clean all parts before assembly.
• Apply NIGTIGHT LYW No.2 grease or equivalent
to each parts.
1) Mount the bush and cushion rubber on the stay.
(A)
(A) Bush
(B) Stay
(C) Cushion rubber
2) Install the bush and spacer to boss.
(B)
(A)
(A) Bush
(B) Spacer
MT GEAR SHIFT LEVER
(C)
(B)
CS-00239
(A)
CS-00238
3) Install the snap ring to gear shift lever, and then
install the bush.
NOTE:
Apply grease to the bush.
(A) Bush
(B) Snap ring
4) Apply grease to the bush and O-ring, and then
install to the gear shift lever.
(A)
(B)
(A) O-ring
(B) Bush
5) Apply sufficient grease into the boss, and then
install the gear shift lever to stay.
CS-27
CONTROL SYSTEMS
(B)
(A)
(A)
CS-00237
CS-00236
CS-00235