Subaru Impreza 2003 Service Manual page 1506

CONTROL SYSTEMS
B: INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
2) Install the select cable to range select lever.
3) Install the plate assembly to transmission.
Tightening torque:
T: 24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
(A)
T
(B)
(A) Select cable
(B) Plate ASSY
4) Install the washer and snap pin to range select
lever.
(D)
(C) (E)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
5) Insert the thread portion of other inner cable and
into connector hole of select lever, and fix the other
outer cable end to the bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13 ft-lb)
6) Move the select lever to "N" range, and then ad-
just the select cable position. <Ref. to CS-15, AD-
JUSTMENT, Select Cable.>
SELECT CABLE
CS-00039
(A)
(B)
CS-00036
7) Install the heat shield cover.
8) Install the front, center, rear exhaust pipe and
muffler. (Non-turbo model)
SOHC model
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.>, <Ref. to EX(H4SO)-9, INSTALLA-
TION, Center Exhaust Pipe.>, <Ref. to EX(H4SO)-
10, INSTALLATION, Rear Exhaust Pipe.> and
<Ref. to EX(H4SO)-12, INSTALLATION, Muffler.>
SOHC without OBD model
<Ref. to EX(H4SOw/oOBD)-7, INSTALLATION,
Front Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)-
9, INSTALLATION, Center Exhaust Pipe.>, <Ref.
to EX(H4SOw/oOBD)-10, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(H4SOw/oOBD)-
11, INSTALLATION, Muffler.>
9) Install center and rear exhaust pipes and muf-
fler. (DOHC turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>, <Ref. to EX(H4DOTC)-14, IN-
STALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(H4DOTC)-15, INSTALLATION, Muffler.>
C: INSPECTION
Check the removed cable and replace if damaged,
rusty, or malfunctioning.
1) Check for smooth operation of the cable.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends, and
cracks.
4) Check the boot for damage, cracks, and deterio-
ration.
5) Move the select lever from "P" range to "1"
range. You should be able to feel the detents in
each position. If the detents cannot be felt or the
position pointer is improperly aligned, adjust the ca-
ble.
CS-14
AT-00682