Subaru Impreza 2003 Service Manual page 1454

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK HARNESS BETWEEN ECM AND
TUMBLE GENERATOR VALVE ACTUATOR
CONNECTOR.
1)Turn the ignition switch to OFF.
2)Disconnect the connector from tumble gen-
erator valve and ECM connector.
3)Measure the resistance between tumble
generator valve actuator and ECM connector.
Connector & terminal
(E51) No. 1 — (B136) No. 10:
(E51) No. 2 — (B136) No. 11:
2 CHECK POOR CONTACT.
Check poor contact in tumble generator valve
actuator connector.
Check
Is the resistance less than 1
Ω?
Is there poor contact in tumble
generator valve actuator con-
nector?
EN(H4DOTC)-278
Yes
Go to step 2. Repair the open
circuit between
ECM and tumble
generator valve
connector.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
ECM and tumble
generator valve
actuator connec-
tor.
• Poor contact in
coupling connec-
tor.
Repair the poor Replace the tum-
contact in tumble ble generator
generator valve valve assembly.
actuator connec- <Ref. to
tor. FU(H4DOTC)-41,
Tumble Generator
Valve Assembly.>
No