NOTE:
Be careful because the spacer must be installed in
proper direction.
(A) (B)
(C) (D) (E) (F) (G) (H)
(A) Driven shaft
(B) Drive shaft
(C) Drive pinion collar
(D) Needle bearing (25 × 30 × 20)
(E) Washer No. 2 (25 × 36 × 4)
(F) Thrust bearing (25 × 37.5 × 3)
(G) Washer No. 1 (25 × 36 × t)
(H) Differential bevel gear sleeve
DRIVE PINION SHAFT ASSEMBLY
MT-00263
5MT-99
MANUAL TRANSMISSION AND DIFFERENTIAL
2. FWD MODEL
1) Assemble gear and hub assembly.
NOTE:
• Use new gear and hub assembly, if gear or hub
have been replaced.
• Be sure the insert keys are correctly located in
the insert key grooves inside the reverse driven
gear.
(C)
(A) Key grooves
(B) Reverse driven gear
(C) 1st driven gear side
(D) 2nd driven gear side
(E) Flush surface
(F) Stepped surface
(B)
(A)
(D)
(E)
(F)
MT-00827