Subaru Impreza 2003 Service Manual page 1894

MANUAL TRANSMISSION AND DIFFERENTIAL
5) Drive the ball bearing onto the rear section of
transmission main shaft using ST1, ST2 and a
press.
ST1 899714110REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using the ST1 and ST2, install the 5th gear
thrust washer and 5th needle bearing race onto the
rear section of transmission main shaft.
NOTE:
Face the thrust washer in correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
7) Install the bearing onto synchro cone.
8) Install the baulk ring and synchro cone onto 5th-
Rev sleeve and hub assembly using ST and a
press.
NOTE:
• Use a new ball bearing.
• After press fitting, make sure the synchro cone
rotates freely.
MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
ST2
ST1
MT-00194
(A)
MT-00195
ST 499757002
(A)
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
9) Install the synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
(A) Synchro cone stopper
(B) Snap ring
10) Install rest of the parts to the rear section of
transmission main shaft.
NOTE:
Align the groove in baulk ring with shifting insert.
(A) (B)
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve and hub ASSY
(E) Lock washer
(F) Lock nuts
5MT-86
INSTALLER
ST
(B)
(C)
(B)
(C) (D)
MT-00196
(A)
MT-00188
(E)
(F)
MT-00198