MANUAL TRANSMISSION AND DIFFERENTIAL
14) Using the ST, remove the differential side re-
tainer on both side.
ST1 499787000
WRENCH ASSY (RIGHT
SIDE)
ST2 18630AA000 WRENCH ASSY (LEFT SIDE)
NOTE:
Be careful not to damage the part of clutch case
where the retainer is to be installed.
(B)
(A)
(A) Left side
(B) Right side
15) Remove the front differential.
B: INSTALLATION
1) Install the differential assembly into clutch hous-
ing.
2) Apply oil to the threaded portion part of side re-
tainer.
3) Remove the O-ring from side retainer of both
side.
4) Using the ST, install the differential side retainer
to both side.
ST1 499787000
WRENCH ASSY (RIGHT
SIDE)
ST2 18630AA000 WRENCH ASSY (LEFT SIDE)
FRONT DIFFERENTIAL ASSEMBLY
ST1
ST2
MT-00657
6MT-106
NOTE:
Be careful not to damage the oil seal.
(B)
(A)
(A) Left side
(B) Right side
5) Install the axle shaft.
NOTE:
• Replace the circlip with a new one.
• Be careful not to confuse right and left axle shaft.
• Wrap vinyl tape around the spline part of axle
shaft.
6) Check and adjust the hypoid gear backlash.
<Ref. to 6MT-110, HYPOID GEAR BACKLASH,
INSPECTION, Front Differential Assembly.>
7) Check and adjust the tooth contact. <Ref. to
6MT-102, ADJUSTMENT, Drive Pinion Shaft As-
sembly.>
8) Mark an engagement point on the right and left
side retainer and clutch housing.
9) Remove the differential side retainer from both
side.
ST1
ST2
MT-00657
MT-00658