Subaru Impreza 2003 Service Manual page 1657

Hide thumbs Also See for Impreza 2003:
Table of Contents

Advertisement

28) Install the oil pump housing assembly.
29) Install the torque converter clutch case assem-
bly to the transmission case assembly. <Ref. to
4AT-98, INSTALLATION, Torque Converter Clutch
Case.>
30) Insert inhibitor switch and transmission con-
nector into stay.
31) Install air breather hose. <Ref. to 4AT-73, IN-
STALLATION, Air Breather Hose.>
(A) Transmission harness
(B) Inhibitor switch harness
32) Install oil cooler pipes. <Ref. to 4AT-72, IN-
STALLATION, ATF Cooler Pipe and Hose.>
33) Install the oil charger pipe with O-ring. <Ref. to
4AT-74, INSTALLATION, Oil Charger Pipe.>
34) Insert the input shaft while turning lightly by
hand. At this time, not to damage the bushing.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
35) Install the torque converter clutch assembly.
<Ref. to 4AT-75, INSTALLATION, Torque Convert-
er Clutch Assembly.>
36) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
AT TRANSMISSION MAIN CASE
AT-00174
AT-00291
4AT-125
AUTOMATIC TRANSMISSION
C: DISASSEMBLY
1. HIGH CLUTCH, REVERSE CLUTCH
1) Remove the snap ring, and take out the retaining
plate, drive plates, driven plates.
(A)
(A) Snap ring
2) Remove snap ring, and take out the retaining
plate, drive plates and driven plates.
(A)
(A) Snap ring
3) Using ST1 and ST2, remove snap ring.
ST1 398673600
COMPRESSOR
ST2 498627100
SEAT
(A)
(A) Snap ring
AT-00236
AT-00237
ST1
ST2
AT-00238

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents