Subaru Impreza 2003 Service Manual page 2102

CLUTCH SYSTEM
10.Clutch Pedal
A: REMOVAL
1. LHD MODEL
• Except 1.6 L MODEL
1) Remove the steering column. <Ref. to PS-26,
REMOVAL, Tilt Steering Column.>
2) Disconnect the connectors from stop light and
clutch switches.
3) Remove the snap pins which secure lever to
push rod and operating rod.
4) Remove the clevis pins which secure lever to
push rod and operating rod.
(A)
(D)
(C)
(A) Operating rod
(B) Push rod
(C) Snap pin
(D) Clevis pin
5) Remove the air cleaner case and intake duct.
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.> and <Ref. to IN(H4SO)-6, REMOVAL, Air
Intake Duct.>
6) Remove the PHV adjusting nut and lock nut.
(Model with hill holder)
(C)
(A) Adjusting nut
(B) Lock nut
(C) PHV
CLUTCH PEDAL
(D)
(C)
(B)
CL-00090
(A)
(B)
CL-00091
7) Remove the cable clamp, and disconnect the
PHV cable from PHV. (Model with hill holder)
CAUTION:
Carefully protect the boot and inner cable from
damage when disconnecting the PHV cable.
(A)
(A) PHV cable
(B) Clamp
8) Remove the nut which secures clutch master
cylinder.
9) Remove the bolts and nuts which secure brake
and clutch pedals, and remove the pedal assembly.
• 1.6 L MODEL
1) Disconnect the ground cable from battery.
2) Remove the air cleaner case and intake duct.
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.> and <Ref. to IN(H4SO)-6, REMOVAL, Air
Intake Duct.>
3) Disconnect the clutch cable from release lever.
4) Remove the instrument panel lower cover.
5) Disconnect the operating rod of brake pedal.
6) Remove the electrical connectors (for stop light
switch, etc.)
CL-40
(B)
CL-00092
CL-00093