Subaru Impreza 2003 Service Manual page 2223

• Heel contact (Outside end contact)
Checking item: Contact area is small.
Contact pattern
Corrective action: Increase thickness of drive pin-
ion height adjusting shim in order to bring drive pin-
ion close to crown gear.
17) If proper tooth contact is not obtained, once
again adjust the drive pinion height by changing RH
and LH side bearing retainer shims and the hypoid
gear backlash.
18) Install the oil seals to the right and left side
bearing retainers.
19) Align the arrow mark on differential carrier with
the mark on side retainer during installation.
(A) Arrow mark
REAR DIFFERENTIAL FOR T-TYPE
AT-00211
AT-00212
(A)
DI-00097
DI-43
20) Tighten the side bearing retainer bolts.
Lock Tite:
THREE BOND 1105 (Part No. 004403010) or
equivalent
Tightening torque:
10.3 N·m (1.05 kgf-m, 7.6 ft-lb)
21) Install the new gasket and rear cover and tight-
en the bolts to specified torque.
Tightening torque:
29 N·m (3.0 kgf-m, 21.7 ft-lb)
22) Install the breather cap.
23) Install the drain plug and filler plug.
Tightening torque:
49 N·m (5.0 kgf-m, 36.2 ft-lb)
DIFFERENTIALS
DI-00098
DI-00113