Subaru Impreza 2003 Service Manual page 1879

Tightening torque:
8 mm bolt
25 N·m (2.5 kgf-m, 18.1 ft-lb)
# # # # 10 mm bolt
39 N·m (4.0 kgf-m, 28.9 ft-lb)
(9)
(5)
(13)
(1)
(15)
(14)
(10)
(6)
7) Tighten the ball bearing attachment bolts.
Tightening torque:
29 N·m (3.0 kgf-m, 21.7 ft-lb)
8) Tighten the input shaft holder attaching bolts.
Tightening torque:
20 N·m (2.0 kgf-m, 14.5 ft-lb)
(A)
(A) Input shaft holder
(B) Input shaft
TRANSMISSION CASE
(16)
(7)
(17)
(11)
(3)
(2)
(4)
(8) (12)
MT-00178
MT-00158
(B)
MT-00163
MANUAL TRANSMISSION AND DIFFERENTIAL
9) Backlash adjustment of hypoid gear and preload
adjustment of roller bearing
NOTE:
Support the drive pinion assembly with ST.
ST 498427100
ST
10) Place the transmission with case left side fac-
ing downward and put ST1 on bearing cup.
11) Screw the retainer assembly into left case from
the bottom using ST2. Fit the ST3 on transmission
main shaft. Shift the gear into 4th or 5th and turn
the shaft several times. Screw in the retainer while
turning ST3 until a slight resistance is felt on ST2.
This is the contact point of hypoid gear and drive
pinion shaft. Repeat the above sequence several
times to ensure the contact point.
ST1 399780104
ST2 499787000
ST3 499927100
ST1
ST2
5MT-71
STOPPER
MT-00174
WEIGHT
WRENCH ASSY
HANDLE
ST3
MT-00175