Subaru Impreza 2003 Service Manual page 1582

AUTOMATIC TRANSMISSION
12) Move the range select lever to parking position
(left side).
(A)
(A) Range select lever
13) Remove the inhibitor switch from transmission.
(A)
(A) Inhibitor switch
14) Disconnect the inhibitor switch harness con-
nector from inhibitor switch.
D: INSTALLATION
1) Connect the inhibitor switch harness connector
to inhibitor switch.
2) Install the inhibitor switch to transmission case.
(A)
(A) Inhibitor switch
3) Move the range select lever to neutral position.
INHIBITOR SWITCH
4) Using the ST, tighten the bolts of inhibitor switch.
ST 499267300
Tightening torque:
3.5 N·m (0.36 kgf-m, 2.6 ft-lb)
AT-00037
5) Install the select cable to range select lever.
6) Install the plate assembly to transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
AT-00038
7) Install the washer and snap pin to range select
lever.
AT-00038
4AT-50
STOPPER PIN
ST
(B)
(A) Inhibitor switch
(B) Range select lever
( A )
T
( B )
(A) Select cable
(B) Plate ASSY
(A)
(C) (D)
(A) Snap ring
(B) Select cable
(C) Range select lever
(D) Washer
(A)
AT-00039
AT-00040
(B)
AT-00034