Subaru Impreza 2003 Service Manual page 1504

CONTROL SYSTEMS
10) Remove the bracket guide assembly.
11) Remove the grommet, and then extract spring
pin from the top.
12) Remove the arm assembly and then take away
the lever and arm bracket from base plate.
(B)
(C)
(A) Arm ASSY
(B) Lever
(C) Base plate
(D) Arm bracket
13) Remove the spring, and then remove the de-
tent arm.
SELECT LEVER
CS-00188
CS-00211
(D)
(A)
CS-00255
CS-12
D: ASSEMBLY
1) Clean all parts before assembly.
2) Apply grease [SUNLIGHT
003602010) or equivalent] to each parts. <Ref. to
CS-3, AT SELECT LEVER, COMPONENT, Gener-
al Description.>
3) Assembly is in the reverse order of disassembly.
4) After completion of fitting, transfer the select le-
ver to range "P" — "1", then check whether the in-
dicator and select lever agree, whether the pointer
and position mark agree and what the operating
force is.
E: INSPECTION
1) Inspect the removed parts by comparing with
new ones for deformation, damage and wear. Cor-
rect or replace if defective.
2) Confirm the following parts for operating condi-
tion before assembly. Moving condition of the se-
lect lever assembly, it should move smoothly.
2 (Part No.