Subaru Impreza 2003 Service Manual page 1581

B: ADJUSTMENT
1) Shift the select lever to "N" range.
2) Loosen the three inhibitor switch securing bolts.
3) Insert the ST as vertical as possible into the
holes in inhibitor switch lever and switch body.
ST 499267300 STOPPER PIN
4) Tighten the three inhibitor switch bolts.
Tightening torque:
3.5 N·m (0.35 kgf-m, 2.5 ft-lb)
5) Repeat the above checks. If the inhibitor switch
is determined to be "faulty", replace it.
C: REMOVAL
1) Set up the vehicle on a lift.
2) Move the select lever to "N" range.
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.>
4) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-10, REMOVAL, Intercool-
er.>
5) Disconnect the inhibitor switch connector.
(A)
(A) Inhibitor switch
6) Remove the inhibitor switch connector from stay.
7) Lift-up the vehicle.
8) Remove the front and center exhaust pipes.
<Ref. to EX(H4SOw/oOBD)-6, REMOVAL, Front
Exhaust Pipe.> or <Ref. to EX(H4SO)-6, REMOV-
AL, Front Exhaust Pipe.>
INHIBITOR SWITCH
S T
AT-00032
AT-00033
4AT-49
AUTOMATIC TRANSMISSION
9) Remove the snap pin and washer from range se-
lect lever.
(C) (D)
(A) Snap pin
(B) Select cable
(C) Range select lever
(D) Washer
10) Remove the plate assembly from transmission
case.
( A )
(A) Select cable
(B) Plate ASSY
11) Remove the bolts.
(A) Inhibitor switch
(A)
(B)
AT-00034
( B )
AT-00035
(A)
AT-00036