Subaru Impreza 2003 Service Manual page 2168

REAR CROSSMEMBER
REAR SUSPENSION
B: INSTALLATION
1. AWD MODEL
NOTE:
• Discard the loosened self-locking nut and re-
place it with a new one.
• Always secure the bolt head and tighten the nut
when tightening the adjusting bolt.
1) Install in the reverse order of removal.
2) For installation and tightening torque of rear dif-
ferential;
T-type
<Ref. to DI-29, INSTALLATION, Rear Differential
for T-type.>
VA-type
<Ref. to DI-55, INSTALLATION, Rear Differential
for VA-type.>
3) Always tighten the rubber bushing when tires are
in full contact with the ground and vehicle is curb
weight.
4) Check the wheel alignment and adjust if neces-
sary.
2. FWD MODEL
NOTE:
• Discard the loosened self-locking nut and re-
place it with a new one.
• Always secure the bolt head and tighten the nut
when tightening adjusting bolt.
1) Install in the reverse order of removal.
2) Always tighten the rubber bushing when tires are
in full contact with the ground and vehicle is curb
weight.
3) Check the wheel alignment and adjust if neces-
sary.
C: INSPECTION
Check the removed parts for wear, damage and
cracks, and correct or replace if defective.
RS-22