Subaru Impreza 2003 Service Manual page 1514

CONTROL SYSTEMS
• Conduct the adjustment of reverse check cable
before installation. <Ref. to CS-34, ADJUSTMENT,
Reverse Check Cable.>
(D)
(B)
(A) Reverse check cable
(B) Washer
(C) Snap pin
(D) Front side
6) Install the rear exhaust pipe and muffler. <Ref. to
EX(H4DOTC)-14, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX(H4DOTC)-15, INSTALLA-
TION, Muffler.>
7) Install the under cover.
8) Install the boot plate.
NOTE:
Install the inner boot without any twist.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
9) Install the console box. <Ref. to EI-42, INSTAL-
LATION, Console Box.>
10) Check that the gear shift is correctly shifted to
each gear.
MT GEAR SHIFT LEVER
(C)
(A)
CS-00224
CS-00219
CS-22
C: DISASSEMBLY
1. 5MT
1) Disassemble the lock wire.
(B)
(A)
(A) Lock wire
(B) Stay
2) Remove the rod from lever.
( A )
( C )
(A) Rod
(B) Lever
(C) Stay
3) Remove the snap ring from bushing B, and then
disconnect the stay.
(B)
(A)
(A) Snap ring
(B) Bushing B
(C) Stay
4) Remove the boot from gear shift lever.
CS-00055
( B )
CS-00056
(C)
CS-00057