Subaru Impreza 2003 Service Manual page 1613

27.Transfer Clutch
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 4AT-39, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove the extension case and remove the
transfer clutch. <Ref. to 4AT-77, REMOVAL, Ex-
tension Case.> and <Ref. to 4AT-78, DISASSEM-
BLY, Extension Case.>
B: INSTALLATION
1) Select the thrust needle bearing. <Ref. to 4AT-
84, ADJUSTMENT, Transfer Clutch.>
2) Install the transfer clutch assembly to the case.
(A)
(B)
(A) Transfer clutch
(B) Extension case
3) Tighten bolts to secure the case.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
4) Install the transmission assembly to vehicle.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
TRANSFER CLUTCH
C: DISASSEMBLY
1) Remove the seal ring.
2) Using a press and ST, remove the ball bearing.
ST 498077600
AT-00125
3) Remove the snap ring, and take out the pressure
plate, drive plates, and driven plates.
AT-00118
4AT-81
AUTOMATIC TRANSMISSION
(A) Seal ring
(B) Transfer clutch
REMOVER
(A) Snap ring
(B) Transfer clutch
AT-00127
AT-00128
AT-00129