Subaru Impreza 2003 Service Manual page 2125

2. CAMBER
• Inspection
1) Place the front wheel on turning radius gauge.
Make sure ground contacting surfaces of front and
rear wheels are set at the same height.
2) Set the ST into the center of wheel, and then in-
stall the wheel alignment gauge.
ST 927380002 ADAPTER
(1)
(2)
(1) Alignment gauge
(2) Turning radius gauge
3) Follow the wheel alignment gauge operation
manual to measure camber angle.
NOTE:
Refer to the "SPECIFICATIONS" for camber val-
ues.
Front: <Ref. to FS-2, SPECIFICATIONS, General
Description.>
Rear: <Ref. to RS-2, SPECIFICATIONS, General
Description.>
• Front Camber Adjustment
1) Loosen the two self-locking nuts located at lower
front portion of strut.
NOTE:
When adjusting bolt needs to be loosened or tight-
ened, hold its head with a wrench and turn self-
locking nut.
WHEEL ALIGNMENT
2) Turn the camber adjusting bolt so that camber is
set at the specification.
NOTE:
Moving the adjusting bolt by one scale graduation
changes camber by approx. 0°10'.
ST
FS-00007
FS-9
FRONT SUSPENSION
(4) (5)
(6) (7)
(2)
(3)
(1) Strut
(2) Adjusting bolt
(3) Housing
(4) Outer
(5) Inner
(6) Camber is increased.
(7) Camber is decreased.
(1)
FS-00008