Subaru Impreza 2003 Service Manual page 1866

MANUAL TRANSMISSION AND DIFFERENTIAL
11.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 5MT-38, REMOVAL, Manual
Transmission Assembly.>
2) Remove the back-up light switch and neutral po-
sition switch. <Ref. to 5MT-48, REMOVAL, Switch-
es and Harness.>
3) Remove the transfer case with extension case
assembly. <Ref. to 5MT-53, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove the extension case assembly.
5) Remove the transfer driven gear.
6) Remove the transfer drive gear.
B: INSTALLATION
1) Install the transfer drive gear.
Tightening torque:
26 N·m (2.7 kgf-m, 20 ft-lb)
2) Install the transfer driven gear.
3) Install the extension case assembly.
4) Install the transfer case and extension case as-
sembly. <Ref. to 5MT-53, INSTALLATION, Trans-
fer Case and Extension Case Assembly.>
5) Install the back-up light switch and neutral posi-
tion switch. <Ref. to 5MT-49, INSTALLATION,
Switches and Harness.>
6) Install the manual transmission assembly from
vehicle. <Ref. to 5MT-41, INSTALLATION, Manual
Transmission Assembly.>
TRANSFER DRIVE GEAR
C: DISASSEMBLY
1) Remove the snap ring.
2) Remove the ball bearing.
MT-00133
D: ASSEMBLY
1) Set the ST applying to inner race of bearing and
install to drive shaft.
ST 398177700
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton)
MT-00133
2) Install the snap ring on transfer drive shaft.
3) Check the clearance between snap ring and ball
bearing. <Ref. to 5MT-59, INSPECTION, Transfer
Drive Gear.>
5MT-58
MT-00135
MT-00136
INSTALLER
ST
MT-00137