Subaru Impreza 2003 Service Manual page 2293

3) Remove the disc cover from housing.
4) Using a standard screwdriver, remove the outer
and inner oil seals.
5) Using a flat tip screwdriver, remove the snap
ring.
NOTE:
Be careful not to damage the housing at removal.
6) Using the ST1, support the housing securely.
7) Using the ST2, hold the inner race to drive out
the outer race of bearing.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING PULLER
FRONT AXLE
DS-00051
DS-00052
ST2
ST1
DS-00053
DS-21
8) Using the ST and a hydraulic press, drive the
hub bolts out.
ST 927080000 HUB STAND
D: ASSEMBLY
NOTE:
When the hub is to be removed from housing, re-
place the bearing set and oil seal with new ones.
1) Attach the hub to ST securely.
ST 927080000 HUB STAND
2) Using a hydraulic press, press new hub bolts un-
til their seating surfaces contact the hub.
NOTE:
Use 12 mm (0.47 in) dia. holes in HUB STAND to
prevent bolts from tilting.
3) Clean dust or foreign particles from inside of
housing.
DRIVE SHAFT SYSTEM
ST
DS-00054
ST
DS-00055