Subaru Impreza 2003 Service Manual page 2026

MANUAL TRANSMISSION AND DIFFERENTIAL
12) Remove the sub gear and spring.
(B)
(A)
(C)
(A) Sub gear
(B) Spring
(C) Punch mark (mark A)
D: ASSEMBLY
1) Install the sub gear and spring.
NOTE:
• Install the spring with white marking on hook part
facing to sub gear side.
• Install the sub gear with punch mark (mark A)
facing outside.
(B)
(A)
(C)
(A) Sub gear
(B) Spring
(C) Punch mark (mark A)
• Install the spring and sub gear, taking care to in-
stall the sub gear installation hole in proper direc-
tion.
(A)
(A) Installation hole
REVERSE IDLER GEAR ASSEMBLY
MT-00628
MT-00628
MT-00629
6MT-96
2) Install the friction plate and snap ring.
NOTE:
Make sure to install the friction plate in proper di-
rection.
(A) Friction plate
(B) Snap ring
(C) Snap ring side
(D) Sub gear side
3) Sufficiently apply gear oil to the shaft, needle
bearing and inner periphery of reverse drive gear.
4) Install the knock pin.
5) Install the washer and needle bearing.
NOTE:
Install the washer with groove facing to reverse
idler gear.
(C)
(B)
(A) Groove
(B) Washer
(C) Needle bearing
(C)
(D)
(B)
(A)
MT-00630
MT-00626
(A)
MT-00631