Subaru Impreza 2003 Service Manual page 1521

11) Install the holder.
Tightening torque:
1.3 N·m (0.13 kgf-m, 0.96 ft-lb)
(A) Holder
12) Insert the reverse check cable into boot hole.
13) Insert the reverse check cable into gear shift
assembly, and fix with band clip.
NOTE:
• Cut off the extra band clip.
• Make sure that the reverse check cable is insert-
ed into gear shift lever assembly without any clear-
ance.
14) Install the seat cushion and spring.
(A) Spring
(B) Seat cushion
MT GEAR SHIFT LEVER
(A)
CS-00230
CS-00227
(A)
(B)
CS-00241
15) Adjust the length between end of cable plate
and reverse check cable to 84 mm (3.31 in), and
then tighten the lock nut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
16) Fix the slider and reverse check cable end with
spring pin.
NOTE:
Apply grease to the sliding part of slider.
(A) Slider
(B) Spring pin
17) Fix the reverse check cable to clip of stay.
NOTE:
Install the reverse check cable to upper side of
stay.
(A)
(A) Reverse check cable
(B) Clip
CS-29
CONTROL SYSTEMS
(A)
(B)
(A)
(B)
CS-00242
CS-00225
CS-00243