Subaru Impreza 2003 Service Manual page 1846

MANUAL TRANSMISSION AND DIFFERENTIAL
3. Manual Transmission As-
sembly
A: REMOVAL
1) Open the front hood fully, and support with stay.
2) Disconnect the ground cable from battery.
3) Remove the air intake duct and cleaner case.
(Non-turbo model) <Ref. to IN(H4SO)-6, REMOV-
AL, Air Intake Duct.> and <Ref. to IN(H4SO)-5, RE-
MOVAL, Air Cleaner Case.>
4) Remove the air cleaner case stay. (Non-turbo
model)
5) Remove the intercooler (Turbo model) <Ref. to
IN(H4DOTC)-10, REMOVAL, Intercooler.>
6) Disconnect the following connectors:
(1) Neutral position switch connector
(2) Back-up light switch connector
(3) High-low switch connector (Dual-range
model)
• NON-TURBO MODEL
• TURBO MODEL
MANUAL TRANSMISSION ASSEMBLY
MT-00062
MT-00063
MT-00064
5MT-38
(4) Vehicle speed sensor
7) Remove the snap pin and clevis pin from drive
select cable.
8) Remove the drive select cable on transmission.
(Dual-range model)
( C )
( B )
(A) Snap pin
(B) Clevis pin
(C) Drive select cable
9) Remove the starter. <Ref. to SC(H4SO)-7, RE-
MOVAL, Starter.>
10) Remove the operating cylinder from transmis-
sion. (2.0 L and 2.5 L model)
• Non-turbo MODEL
MT-00065
( A )
MT-00066
MT-00067