Subaru Impreza 2003 Service Manual page 2306

DRIVE SHAFT SYSTEM
C: DISASSEMBLY
1) Place alignment marks on shaft and outer race.
2) Remove the SFJ boot band and boot.
CAUTION:
Be careful not to damage the boot.
3) Remove the circlip from SFJ outer race using a
screwdriver.
4) Remove the SFJ outer race from shaft assem-
bly.
5) Wipe off the grease.
CAUTION:
The grease is a special grease. Do not confuse
with other greases.
FRONT DRIVE SHAFT
6) Place alignment marks on free ring and trunnion.
DS-00205
7) Remove the free ring from trunnion.
CAUTION:
Be careful with the free ring position.
DS-00206
8) Place an alignment mark on trunnion and shaft.
9) Remove the snap ring and trunnion.
DS-00207
CAUTION:
Be sure to wrap the shaft splines with vinyl tape
to prevent the boot from scratches.
10) Remove the SFJ boot.
DS-34
DS-00208
DS-00110
DS-00209