Subaru Impreza 2003 Service Manual page 2110

CLUTCH SYSTEM
11.Clutch Cable
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the air cleaner case and intake duct.
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.> and <Ref. to IN(H4SO)-6, REMOVAL, Air
Intake Duct.>
3) Disconnect the clutch cable from release lever.
4) Depress the clutch pedal to the floor.
5) Remove the clutch cable clamp from pedal
bracket.
(A)
(B)
(A) Clamp
(B) Clutch cable
6) Remove the clutch cable from body.
B: INSTALLATION
1) Clean the clutch pedal fitting hole, and apply
grease. Connect the clutch cable to body.
2) Fit the clutch pedal to pedal bolt, and connect
the clutch cable to bracket with clamp.
3) Connect the clutch cable end to pedal end.
4) Connect the clutch cable to release lever.
5) Install the grommet to toe board.
6) Adjust the cable after installation. <Ref. to CL-
45, ADJUSTMENT, Clutch Pedal.>
7) Install the air cleaner case and intake duct. <Ref.
to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.> and <Ref. to IN(H4SO)-6, INSTALLATION,
Air Intake Duct.>
C: INSPECTION
Check the removed cable and replace if damaged,
rusty, or malfunctioning.
1) Check for smooth operation of the cable.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends, and
cracks.
4) Check the boot for damage, cracks, and deterio-
ration.
CLUTCH CABLE
CL-00230
CL-48