Subaru Impreza 2003 Service Manual page 2227

14) Fit a new oil seal with ST.
NOTE:
• Press-fit until the end of oil seal is 1 mm (0.04 in)
inward from end of carrier.
• Apply grease between the oil seal lips.
ST 498447120 INSTALLER
ST
15) Press-fit the companion flange with ST1, ST2
and ST3.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
ST3 498937110 HOLDER DRIVE PINION
NOTE:
Be careful not to damage the bearing.
ST1
ST2
16) Install the self-lock nut. Then tighten it with the
ST.
ST 498427200 FRANGE WRENCH
REAR DIFFERENTIAL FOR T-TYPE
DI-00089
ST3
ST2
DI-00323
ST
DI-00071
17) Install the crown gear on differential case.
NOTE:
Before installing the bolts, apply Lock Tite to bolt
threads.
Lock Tite:
THREE BOND 1324 (Part No.004403042) or
equivalent
NOTE:
Tighten diagonally while tapping the bolt heads.
Tightening torque:
105 N·m (10.7 kgf-m, 77.4 ft-lb)
18) Press-fit the side bearing onto differential case
with ST.
ST 398487700
19) Assembling side retainer.
(1) Press-fit the side bearing outer race with
press and ST.
ST 398417700
(2) Install the oil seal. <Ref. to DI-71, RE-
PLACEMENT, Rear Differential Side Oil Seal.>
DI-47
DIFFERENTIALS
DRIFT
ST
DRIFT
ST
DI-00068
DI-00095
DI-00324