Subaru Impreza 2003 Service Manual page 1586

AUTOMATIC TRANSMISSION
2) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body using clips.
Tightening torque (Transmission ground cable)
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(B)
(C)
(A)
(J)
(G)
(A) Lock-up duty solenoid (Blue)
(B) Transmission ground
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Low clutch timing solenoid (Gray)
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
THREE BOND 1217B (Part No. K0877YA020)
FRONT VEHICLE SPEED SENSOR
(D)
(E)
(K)
(I)
(H)
(F)
AT-00695
AT-00051
4AT-54
4) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Fluid packing:
THREE BOND 1217B (Part No. K0877YA020)
5) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6) Install the front and rear vehicle speed sensor,
and also the torque converter turbine speed sen-
sor, and then fasten the harness.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
7) Install the oil cooler pipes.
NOTE:
Be sure to use a new copper washer.
Tightening torque:
T1: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T2: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
T1
8) Install the transmission rear crossmember bolts.
Tightening torque:
70 N·m (7.1 kgf-m, 51 ft-lb)
9) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
10) Install the shield cover. (If equipped)
AT-00052
T1
T2
AT-00805