Subaru Impreza 2003 Service Manual page 1629

33.Parking Pawl
A: REMOVAL
1) Remove the transmission assembly from the ve-
hicle. <Ref. to 4AT-39, REMOVAL, Automatic
Transmission Assembly.>
2) Remove rear vehicle speed sensor and separate
transmission case and extension case sections.
<Ref. to 4AT-77, REMOVAL, Extension Case.>
3) Remove the reduction drive gear. (MPT model)
<Ref. to 4AT-93, REMOVAL, Reduction Drive
Gear.>
4) Remove the center differential carrier. (VTD
model) <Ref. to 4AT-95, REMOVAL, Center Differ-
ential Carrier.>
5) Remove the parking pawl, return spring and
shaft.
(A)
(A) Return spring
(B) Parking pawl
PARKING PAWL
(B)
AT-00171
4AT-97
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the parking pawl, shaft and return spring.
(A)
(A) Return spring
(B) Parking pawl
2) Install the reduction drive gear. <Ref. to 4AT-93,
INSTALLATION, Reduction Drive Gear.>
3) Install the center differential carrier. (VTD model)
<Ref. to 4AT-95, INSTALLATION, Center Differen-
tial Carrier.>
4) Install the rear vehicle speed sensor and exten-
sion case. <Ref. to 4AT-77, INSTALLATION, Ex-
tension Case.>
5) Install the transmission assembly to the vehicle.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Make sure that the tab of the packing pole on the
reduction gear is not worn or otherwise damaged.
(B)
AT-00171