Subaru Impreza 2003 Service Manual page 2095

4) Remove the oil seal.
5) Move the cylinder boot backward.
(B)
(A) Cylinder boot
(B) Master cylinder
6) Remove the stop ring.
CAUTION:
Be careful when removing the snap ring to pre-
vent the rod, washer, piston and return spring
from flying out.
7) Remove the air bleeder.
D: ASSEMBLY
1. EXCEPT RHD DOHC TURBO MODEL
1) Install the clutch damper.
Tightening torque:
46.6 N·m (4.75 kgf-m, 34.4 ft-lb)
2) Apply a coat of grease to the contacting surfaces
of the push rod and piston before installation.
MASTER CYLINDER
CL-00052
(A)
CL-00048
Grease:
SILICONE GREASE G40M (Part No.
004404003)
3) To assemble the master cylinder, reverse the
sequence of disassembly procedure.
Tightening torque:
10 N·m (1.0 kgf-m, 7 ft-lb)
2. RHD DOHC TURBO MODEL
1) Apply a coat of grease to the contacting surfaces
of the push rod and piston before installation.
Grease:
SILICONE GREASE G40M (Part No.
004404003)
2) Assemble in the reverse order of disassemble.
CL-33
CLUTCH SYSTEM
CL-00054
CL-00055