Subaru Impreza 2003 Service Manual page 1995

5) If replacing the oil pump cover assembly, select
the transfer driven gear and thrust washer, then in-
stall them to the extension case. <Ref. to 6MT-51,
ADJUSTMENT, Extension Case.>
6) Install the selector arm No.2 and shifter arm.
(A)
(A) Selector arm No. 2
(B) Shift arm
7) Install a new spring pin.
8) Install the support to neutral set spring.
NOTE:
Make sure to install the support in proper direction.
9) Using the ST, install the neutral set spring and
support.
ST1 18756AA000 CLAW
ST2 398663600 PLIERS
ST2 ST2
10) Install the snap ring.
OIL PUMP
(B)
MT-00488
MT-00491
ST1
MT-00486
6MT-65
MANUAL TRANSMISSION AND DIFFERENTIAL
11) Install the oil guide.
(A) Oil guide
12) Install the center differential. <Ref. to 6MT-62,
INSTALLATION, Center Differential.>
13) Install the transfer driven gear. <Ref. to 6MT-
60, INSTALLATION, Transfer Driven Gear.>
14) Install the extension case. <Ref. to 6MT-49, IN-
STALLATION, Extension Case.>
15) Install the manual transmission assembly to ve-
hicle. <Ref. to 6MT-39, INSTALLATION, Manual
Transmission Assembly.>
C: INSPECTION
1) Make sure there is no damage on the inner rotor
and outer rotor. Replace the inner rotor and outer
rotor as assembly if damaged.
2) Clearance at tip
Install the inner rotor and outer rotor to transmis-
sion case. Align tip of the inner rotor and outer ro-
tor, then measure the clearance. Replace the inner
rotor and outer rotor as a set if clearance exceeds
specification.
Specification of clearance at tip:
Less than 0.15 mm (0.0059 in)
(A)
MT-00520
MT-00524