Subaru Impreza 2003 Service Manual page 2253

12) Insert the DOJ into rear differential.
(1) Install the ST to rear differential.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
ST
(2) Install the spline shaft until the spline portion
is inside the side oil seal using ST.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
(3) Remove the ST.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
13) Hereafter, reassemble in the reverse order of
disassembly.
2. VA-TYPE
1) Disconnect the ground cable from battery.
2) Move the select lever or gear shift lever to "N".
3) Release the parking brake.
4) Loosen both wheel nuts.
5) Jack-up the vehicle and support it with rigid
racks.
6) Remove the wheels.
7) Remove the rear exhaust pipe and muffler.
Non-turbo model without OBD
<Ref. to EX(H4SOw/oOBD)-10, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SOw/oOBD)-
11, REMOVAL, Muffler.>
Non-turbo model with OBD
<Ref. to EX(H4SO)-10, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H4SO)-12, REMOVAL,
Muffler.>
8) Remove the DOJ of rear drive shaft from rear dif-
ferential.
REAR DIFFERENTIAL SIDE OIL SEAL
DI-00325
ST
DI-00060
DI-73
(1) Remove the ABS wheel speed sensor cable
clamp and parking brake cable clamp from
bracket.
(A)
(A) ABS wheel speed sensor cable clamp
(B) Parking brake cable clamp
(2) Remove the ABS wheel speed sensor cable
clamp from trailing link.
(3) Remove the ABS wheel speed sensor cable
clamp and parking brake cable guide from trail-
ing link.
(A) Parking brake cable guide
(B) ABS wheel speed sensor cable clamp
DIFFERENTIALS
(B)
DI-00200
DI-00201
(A)
(B)
DI-00202