Subaru Impreza 2003 Service Manual page 1600

TRANSFER DUTY SOLENOID AND VALVE BODY
AUTOMATIC TRANSMISSION
4) Install the transmission rear crossmember.
(1) Tighten the bolts.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2
(2) Remove the transmission jack.
5) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
6) Install the front, center rear exhaust pipe and
muffler. (Non-turbo model)
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.>, <Ref. to EX(H4SO)-10, INSTALLA-
TION, Rear Exhaust Pipe.> and <Ref. to
EX(H4SO)-12, INSTALLATION, Muffler.>
7) Install center and rear exhaust pipes, and muf-
fler. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>, <Ref. to EX(H4DOTC)-14, IN-
STALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(H4DOTC)-15, INSTALLATION, Muffler.>
8) Connect the transmission harness connector.
T1
T2
AT-00088
AT-00089
9) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
10) Install the air cleaner case. (2.0 L Non-turbo
and 2.5 L models)
<Ref. to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.>
11) Install intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-11, INSTALLATION, Inter-
cooler.>
12) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to 4AT-
31, Automatic Transmission Fluid.>
13) Check the ATF level. <Ref. to 4AT-31, Auto-
matic Transmission Fluid.>
4AT-68
T2 T1
AT-00691