Subaru Impreza 2003 Service Manual page 2018

MANUAL TRANSMISSION AND DIFFERENTIAL
9) Using the ST, remove each parts.
ST 18754AA000 REMOVER
ST
(E)
ST
(A) 2nd bush
(B) 1st-2nd hub
(C) Outer baulk ring
(D) 1st synchro cone
(E) Inner baulk ring
(F) 1st driven gear
(G) 1st needle bearing
D: ASSEMBLY
NOTE:
Replace the following parts as a set.
• Sleeve and hub
• Outer baulk ring, 1st synchro cone, inner baulk
ring
• Outer baulk ring, 2nd synchro cone, inner baulk
ring
1) Sufficiently apply gear oil to the drive shaft, 1st
needle bearing and inner periphery of 1st driven
gear.
2) Install the 1st needle bearing.
DRIVEN GEAR ASSEMBLY
3) Install the 1st driven gear to driven shaft.
4) Install the inner baulk ring.
(A)
(B)
(C)
(D)
(F)
(G)
MT-00594
5) Align protrusion portions of the 1st synchro cone
to the holes of 1st drive gear to install.
6) Install the outer baulk ring.
7) Install the 1st-2nd hub.
NOTE:
• Align the protrusion portion of outer baulk ring
and cutout portion of 1st-2nd hub, then install.
MT-00595
6MT-88
MT-00596
MT-00597
MT-00598
MT-00599