Subaru Impreza 2003 Service Manual page 2104

CLUTCH SYSTEM
10) Depress the clutch pedal, then disconnect the
clutch cable from clutch pedal. (1.6 L model)
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
• If the cable clamp is damaged, replace it with
a new one.
• Never fail to cover the outer cable end with
boot.
• Be careful not to kink the accelerator cable.
• Always use new clevis pins.
2) Adjust the clutch pedal after installation. <Ref. to
CL-45, ADJUSTMENT, Clutch Pedal.>
C: DISASSEMBLY
1. LHD MODEL
• Except 1.6 L MODEL
1) Remove the clips, assist spring, rod and bush-
ing.
(D)
(A)
(E)
(C)
(D)
(B)
(E)
(C)
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
2) Remove the spring pin and lever.
(A) Pin
(B) Lever
CLUTCH PEDAL
(D)
CL-00094
(A)
(B)
CL-00095
3) Remove the clutch pedal and bushings.
(B)
(A)
(A) Clutch pedal
(B) Bushing
4) Remove the stopper, clip, O-ring, rod S, and
then remove the spring and bushing S.
(F)
(E)
(A) Clip
(B) O-ring
(C) Bushing S
(D) Spring S
(E) Rod S
(F) Stopper
5) Remove the stoppers from clutch pedal.
6) Remove the clutch pedal pad. (Non-turbo mod-
el)
CL-42
CL-00096
(C)
(A)
(B)
(D)
CL-00217
(B)