Subaru Impreza 2003 Service Manual page 1596

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
AUTOMATIC TRANSMISSION
17.Shift Solenoids, Duty Sole-
noids and ATF Temperature
Sensor
A: REMOVAL
1. SHIFT SOLENOIDS AND DUTY SOLE-
NOIDS
1) Lift-up the vehicle.
2) Clean the transmission exterior.
3) Replace the gasket with a new one, and tighten
the drain plug.
4) Drain the ATF completely.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
5) Remove the oil pan.
6) Disconnect the solenoid and duty solenoid con-
nectors.
(C)
(A)
(G)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) Sport shift solenoid (Beige) (if equipped)
( B )
( A )
AT-00080
(B)
(D)
(E)
(J)
(I)
(H)
(F)
AT-00902
7) Remove the solenoids and duty solenoids.
(A)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Sport shift solenoid (Beige) (if equipped)
2. ATF TEMPERATURE SENSOR
For removal of ATF temperature sensor, refer to
"Front Vehicle Speed Sensor." <Ref. to 4AT-52,
REMOVAL, Front Vehicle Speed Sensor.>
B: INSTALLATION
1. SHIFT SOLENOIDS AND DUTY SOLE-
NOIDS
1) Insert solenoid and duty solenoid to specified
position.
(A)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) SPORT shift solenoid (Beige) (if equipped)
4AT-64
(C)
(D)
(E)
(B)
(H)
(G)
(F)
AT-00903
(C)
(D)
(E)
(B)
(H)
(G)
(F)
AT-00903