Subaru Impreza 2003 Service Manual page 1572

AUTOMATIC TRANSMISSION
13) Remove the ATF level gauge.
NOTE:
Plug the opening to prevent an entry of foreign par-
ticles into transmission fluid.
14) Set the ST.
ST 41099AA000 ENGINE SUPPORT ASSY
15) Remove the bolt which holds the right upper
side of transmission to engine.
16) Lift-up the vehicle.
17) Remove the under cover.
18) Remove the front, center and rear exhaust
pipe, and muffler. (Non-turbo model)
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-10, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SO)-12, RE-
MOVAL, Muffler.>
19) Remove the center and rear exhaust pipes,
and muffler. (Turbo model)
<Ref. to EX(H4DOTC)-9, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOTC)-14, REMOV-
AL, Rear Exhaust
EX(H4DOTC)-15, REMOVAL, Muffler.>
AUTOMATIC TRANSMISSION ASSEMBLY
AT-00680
ST
AT-00105
AT-00106
Pipe.> and <Ref.
20) Remove the heat shield cover. (If equipped)
21) Drain ATF to remove the ATF drain plug.
(A) Oil pan
(B) Drain plug
22) Disconnect the ATF cooler hoses from pipes of
transmission side, and remove the ATF level gauge
guide.
23) Remove the propeller shaft.
<Ref. to DS-15, REMOVAL, Propeller Shaft.>
24) Remove the shift select cable. <Ref. to CS-13,
REMOVAL, Select Cable.>
25) Disconnect the stabilizer link from transverse
link.
to
4AT-40
AT-00682
( B )
( A )
AT-00080
AT-00683