Subaru Impreza 2003 Service Manual page 1577

10.Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air cleaner case. (2.0 L Non-turbo
model)
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.>
3) Remove the intercooler. (2.0 L Turbo model)
<Ref. to IN(H4DOTC)-10, REMOVAL, Intercool-
er.>
4) Remove the pitching stopper.
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle and support it with sturdy
racks.
3) Remove the front, center, rear exhaust pipes
and muffler. (Non-turbo model)
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-10, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SO)-12, RE-
MOVAL, Muffler.>
4) Remove the center and rear exhaust pipes, and
muffler. (Turbo model)
<Ref. to EX(H4DOTC)-9, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOTC)-14, REMOV-
AL, Rear Exhaust
EX(H4DOTC)-15, REMOVAL, Muffler.>
5) Remove the heat shield cover. (If equipped)
6) Set the transmission jack under the transmis-
sion. Make sure that the support plates of transmis-
sion jack don't touch the oil pan.
TRANSMISSION MOUNTING SYSTEM
AT-00679
Pipe.> and <Ref.
7) Remove the transmission rear crossmember.
8) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
2) Install the air cleaner case. (Non-turbo model)
<Ref. to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.>
3) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-11, INSTALLATION, Inter-
cooler.>
to
4AT-45
AUTOMATIC TRANSMISSION
T2 T1
AT-00024
AT-00691