Subaru Impreza 2003 Service Manual page 1788

DIAGNOSTIC PROCEDURE WITHOUT DIAGNOSTIC TROUBLE CODE (DTC)
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Step
57 CHECK HARNESS CONNECTOR BETWEEN
TCM AND COMBINATION METER.
1)Disconnect the connectors from TCM and
combination meter.
2)Measure the resistance of harness between
TCM and combination meter.
Connector & terminal
(B55) No. 6 — (i12) No. 4:
58 CHECK HARNESS CONNECTOR BETWEEN
TCM AND INHIBITOR SWITCH.
1)Turn the ignition switch to OFF.
2)Disconnect the connectors from TCM, inhibi-
tor switch and combination meter.
3)Measure the resistance of harness between
TCM and chassis ground.
Connector & terminal
(B55) No. 6 — Chassis ground:
59 CHECK HARNESS CONNECTOR BETWEEN
TCM AND INHIBITOR SWITCH.
1)Turn the ignition switch to OFF.
2)Disconnect the connectors from TCM and
inhibitor switch.
3)Measure the resistance of harness between
TCM and inhibitor switch connector.
Connector & terminal
(B55) No. 7 — (T7) No. 6:
60 CHECK INPUT SIGNAL FOR TCM.
1)Turn the ignition switch to OFF.
2)Connect the connector to TCM and inhibitor
switch.
3)Turn the ignition switch to ON.
4)Move the select lever to "1" range.
5)Measure the voltage between TCM and
chassis ground.
Connector & terminal
(B55) No. 7 (+) — Chassis ground (–):
61 CHECK INPUT SIGNAL FOR TCM.
1)Position the select lever to any other than "1"
range.
2)Measure the voltage between TCM and
chassis ground.
Connector & terminal
(B55) No. 7 (+) — Chassis ground (–):
62 CHECK "1" RANGE INDICATOR LIGHT
BULB.
1)Turn the ignition switch to OFF.
2)Remove the combination meter.
3)Remove the "1" range indicator light bulb
from combination meter.
63 CHECK HARNESS CONNECTOR BETWEEN
TCM AND COMBINATION METER.
1)Disconnect the connectors from TCM and
combination meter.
2)Measure the resistance of harness between
TCM and combination meter.
Connector & terminal
(B55) No. 7 — (i12) No. 5:
Check
Is the resistance less than 1
Ω?
Is the resistance more than 1
MΩ?
Is the resistance less than 1
Ω?
Is the voltage less than 1 V?
Is the voltage more than 8 V?
Is the "1" range indicator light
bulb OK?
Is the resistance less than 1Ω? Go to step 65.
4AT-118
Yes
Go to step 65. Repair the open
circuit in harness
between TCM and
combination
meter, and poor
contact in TCM
connector.
Go to step 59. Repair the ground
short circuit in "2"
range circuit.
Go to step 60. Repair the open
circuit in harness
between TCM and
inhibitor switch
connector, and
poor contact in
coupling connec-
tor.
Go to step 61. Go to step 65.
Go to step 65. Replace the TCM.
<Ref. to 4AT-70,
Transmission Con-
trol Module
(TCM).>
Go to step 63. Replace the "1"
range indicator
light bulb. <Ref. to
IDI-14, Combina-
tion Meter Assem-
bly.>
Repair the open
circuit in harness
between TCM and
combination
meter, poor con-
tact in TCM con-
nector.
No