Subaru Impreza 2003 Service Manual page 2014

MANUAL TRANSMISSION AND DIFFERENTIAL
2) Set the height gauge to adapter plate. Lower the
indicator of height gauge to mating surface of
adapter plate and case, then set to zero point.
ST 18853AA000 HEIGHT GAUGE
ST
NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the adapter plate is base point
of measurement.
• Do not place the height gauge on shaded area in
the figure during measurement.
MAIN SHAFT ASSEMBLY
3) Measure the height to edge surface of ball bear-
ing (height A1).
MT-00582
NOTE:
Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
bearing.
MT-00583
Measure five points of the ball bearing turning ev-
ery approx. 120°. Round off each two upper and
lower measurement value. Use the remaining cen-
ter value as measurement value.
4) According to measurement value, select the
snap ring and washer from the following table.
6MT-84
(A)
(A) Ball bearing
MT-00584
(2)
(1)
MT-00585