Subaru Impreza 2003 Service Manual page 1648

Hide thumbs Also See for Impreza 2003:

Table of Contents

AUTOMATIC TRANSMISSION

6) Using ST, install taper roller bearing.

ST 398437700

(A) Taper roller bearing

2. SIDE RETAINER

1) Install bearing outer race to side retainer.

2) Install a new oil seal using the ST and hammer.

ST 499797000

3) Install new O-ring.

E: INSPECTION

• Check each component for harmful cuts, dam-

age and other faults.

• Measure the backlash and adjust to within spec-

<Ref. to 4AT-116, ADJUSTMENT, Front Differen-

FRONT DIFFERENTIAL

F: ADJUSTMENT

1) Using ST, screw in the retainer until light contact

Screw in the RH side slightly deeper than the LH

ST 499787000

2) Remove the oil pump housing.

3) Thoroughly remove the liquid gasket from the

case mating surface beforehand.

4) Install the oil pump housing assembly to the

torque converter clutch case, and secure evenly by

tightening four bolts.

Use an old gasket or an aluminum washer so as not

to damage the mating surface of the housing.

Tightening torque:

41 N·m (4.2 kgf-m, 30.4 ft-lb)

5) Rotate the drive pinion several times with ST1

ST1 498937110

ST2 499787700

Show Quick Links

Chapters

Table of Contents