Subaru Impreza 2003 Service Manual page 2301

11) Install the brake drum on rear housing assem-
bly.
12) Bleed the air from brake system. <Ref. to BR-
61, REPLACEMENT, Brake Fluid.>
13) Adjust the parking brake lever stroke by turning
the adjuster.
14) Move the brake lever back to apply brakes.
While depressing the brake pedal, tighten the axle
nut using a socket wrench. Lock the axle nut after
tightening.
Tightening torque:
186 N·m (19 kgf-m, 137 ft-lb)
CAUTION:
Do not overtighten it as this may damage the
wheel bearing.
15) Connect the rear ABS wheel speed sensor to
back plate.
(1) ABS wheel speed sensor
16) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
88 N·m (9.0 kgf-m, 65 ft-lb)
17) Make the tires contact the ground fully.
CAUTION:
Make the tires contact the ground fully and the
vehicle be in curb weight whenever carrying
out the tightening of bush portions.
18) Tighten the installation bolt of rear housing as-
sembly and lateral link assembly.
Tightening torque:
137 N·m (14 kgf-m, 101 ft-lb)
19) Tighten the installation bolt of rear housing as-
sembly and trailing link assembly.
Tightening torque:
90 N·m (9.2 kgf-m, 66 ft-lb)
REAR AXLE
C: DISASSEMBLY
1) Using the ST1 and ST2, remove the hub from
rear housing.
ST1 927080000
ST2 927420000
2) Remove the back plate from rear housing.
3) Using a standard screwdriver, remove the outer
and inner oil seals.
4) Using a flat tip screwdriver, remove the snap
ring.
NOTE:
Be careful not to damage the housing at removal.
( 1 )
DS-00069
5) Using the ST1 and ST2, remove the bearing by
pressing the inner race.
ST1 927430000
ST2 927440000
6) Remove the tone wheel bolts, and then remove
the tone wheel from hub (Model with ABS).
DS-29
DRIVE SHAFT SYSTEM
HUB STAND
HUB REMOVER
ST2
ST1
HOUSING STAND
BEARING REMOVER
ST2
DS-00088
DS-00089
ST1
DS-00090