Subaru Impreza 2003 Service Manual page 1849

25) Remove the spring pins and separate the front
drive shafts from each side of transmission.
NOTE:
Discard the removing spring pin. Replace with a
new one.
26) Remove the nuts which hold the lower side of
transmission to engine.
27) Place the transmission jack under transmis-
sion.
CAUTION:
Always support the transmission case with a
transmission jack.
MANUAL TRANSMISSION ASSEMBLY
MT-00805
MT-00077
MT-00078
5MT-41
MANUAL TRANSMISSION AND DIFFERENTIAL
28) Remove the transmission rear crossmember
from vehicle.
29) Remove the transmission.
NOTE:
Move the transmission jack toward rear until main
shaft is withdrawn from clutch cover.
30) Separate the transmission assembly and rear
cushion rubber.
B: INSTALLATION
1) Install the rear cushion rubber to transmission
assembly.
Tightening torque:
35 N·m (3.57 kgf-m, 25.8 ft-lb)
2) Install the clutch release lever and bearing onto
transmission. (Turbo model) <Ref. to CL-26, IN-
STALLATION, Release Bearing and Lever.>
3) Install the transmission onto engine.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
NOTE:
Be careful not to strike the main shaft against clutch
cover.
4) Install the transmission rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
5) Take off the transmission jack.
MT-00079
T 1
T 2
MT-00081