Subaru Impreza 2003 Service Manual page 2211

10) Drive out the pinion shaft lock pin from crown
gear side. (Model without LSD)
NOTE:
The lock pin is staked at the pin hole end on the dif-
ferential carrier; do not drive it out forcibly before
unstaking it.
ST 899904100 STRAIGHT PIN REMOVER
11) Draw out the pinion mate shaft and remove the
pinion mate gears, side gears and thrust washers.
(Model without LSD)
NOTE:
The gears as well as thrust washers should be
marked or kept separated right and left, front and
rear.
(A) Side gear
(B) Pinion mate gear
(C) Thrust washer
(D) Differential case
(E) Pinion mate shaft
REAR DIFFERENTIAL FOR T-TYPE
DI-00237
DI-00238
DI-31
12) Hold the companion flange with ST and remove
the drive pinion nut.
ST 498427200 FLANGE WRENCH
13) Extract the companion flange with a puller.
14) Press the end of drive pinion shaft and extract it
together with the rear bearing cone, preload adjust-
ing spacer and washer.
NOTE:
Hold the drive pinion so as not to drop it.
ST 398467700 DRIFT
DIFFERENTIALS
ST
DI-00071
DI-00072
ST
DI-00073