Subaru Impreza 2003 Service Manual page 1584

AUTOMATIC TRANSMISSION
13.Front Vehicle Speed Sensor
A: REMOVAL
1) Set up the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.>
4) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-10, REMOVAL, Intercool-
er.>
5) Disconnect the transmission connector.
(A) Transmission connector
6) Remove the pitching stopper. <Ref. to 4AT-45,
REMOVAL, Transmission Mounting System.>
7) Remove the transmission connector from stay.
8) Lift-up the vehicle.
9) Clean the transmission exterior.
FRONT VEHICLE SPEED SENSOR
AT-00041
( A )
AT-00042
10) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(C)
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
11) Remove the front, center, exhaust pipes and
muffler. (Non-turbo model)
<Ref. to EX(H4SOw/oOBD)-6, REMOVAL, Front
Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)-10,
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(H4SOw/oOBD)-11, REMOVAL, Muffler.> or
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-10, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SO)-12, RE-
MOVAL, Muffler.>
12) Remove the center, rear exhaust pipe and muf-
fler. (Turbo model)
<Ref. to EX(H4DOTC)-9, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOTC)-14, REMOV-
AL, Rear Exhaust
EX(H4DOTC)-15, REMOVAL, Muffler.>
13) Remove the shield cover. (If equipped)
14) Remove the propeller shaft. <Ref. to DS-15,
REMOVAL, Propeller Shaft.>
15) Place the transmission jack under transmis-
sion.
NOTE:
Make sure that the support plates of transmission
jack don't touch the crossmember.
4AT-52
(B)
(A)
AT-00016
Pipe.> and <Ref. to