Subaru Impreza 2003 Service Manual page 2302

DRIVE SHAFT SYSTEM
7) Using the ST, press the hub bolt out.
ST 927080000 HUB STAND
CAUTION:
Be careful not to hammer the hub bolts. This
may deform the hub.
D: ASSEMBLY
NOTE:
When the hub is to be removed from housing, re-
place the bearing set and oil seal with new ones.
1) Using the ST, press the new hub bolt into place.
NOTE:
• Ensure the hub bolt closely contacts the hub.
• Use a 12 mm (0.47 in) hole in the ST to prevent
the hub bolt from tilting during installation.
ST 927080000 HUB STAND
REAR AXLE
ST
DS-00054
ST
DS-00055
DS-30
2) Remove foreign particles (dust, rust, etc.) from
mating surfaces of the hub tone wheel, and then in-
stall the tone wheel to hub (Model with ABS).
NOTE:
• Ensure the tone wheel closely contacts the hub.
• Be careful not to damage the tone wheel teeth.
(1)
(1) Tone wheel
3) Clean the housing interior completely. Using the
ST1 and ST2, press the bearing into housing.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
NOTE:
• Always press the outer race when installing the
bearing.
• Be careful not to remove the plastic lock from in-
ner race when installing the bearing.
4) Using pliers, install the snap ring firmly.
(1) Pliers
DS-00093
ST2
ST1
DS-00094
(1)
DS-00095