Subaru Impreza 2003 Service Manual page 2329

4. Front ABS Wheel Speed Sen-
sor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the front ABS wheel speed sensor
connector located next to the front strut mounting
house in engine compartment. Pull the connector
out from grommet hole to tire side.
3) Remove the bolts which secure the sensor har-
ness to strut.
4) Remove the bolts which secure the sensor har-
ness to body.
(1) To front ABS wheel speed sensor connector
(2) Bracket
5) Remove the bolts which secure the front ABS
wheel speed sensor to housing, and remove the
front ABS wheel speed sensor.
CAUTION:
• Be careful not to damage the pole piece locat-
ed at tip of the sensor and teeth faces during re-
moval.
FRONT ABS WHEEL SPEED SENSOR
ABS00140
(1)
(2)
ABS00141
ABS-13
• Do not pull the sensor harness during remov-
al.
B: INSTALLATION
1) Temporarily install the front ABS wheel speed
sensor on housing.
CAUTION:
Be careful not to strike the ABS wheel speed
sensor's pole piece against tone wheel and ad-
jacent metal parts during installation.
2) Install the front ABS wheel speed sensor on strut
and wheel apron bracket.
Tightening torque:
33 N·m (3.3 kgf-m, 24 ft-lb)
(1) To front ABS wheel speed sensor connector
(2) Bracket
ABS
ABS00142
ABS00142
(1)
(2)
ABS00141