Subaru Impreza 2003 Service Manual page 1528

CONTROL SYSTEMS
7. MT Drive Select Lever
A: REMOVAL
1) Set the drive select lever to HI position.
2) Remove the knob.
(A) Drive select lever knob
3) Remove the console box. <Ref. to EI-42, RE-
MOVAL, Console Box.>
4) Remove the bolt installing drive select lever as-
sembly on body.
5) Remove the flange nut, clip and then disconnect
the cable from lever assembly.
(A)
(C)
(A) Flange nut
(B) Lever ASSY
(C) Clip
MT DRIVE SELECT LEVER
( A )
CS-00190
CS-00102
(B)
CS-00067
B: INSTALLATION
1) Attach the drive select cable to the lever assem-
bly and secure with the clamp.
(A)
(C)
(A) Flange nut
(B) Lever ASSY
(C) Clip
2) Install the drive select lever.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
3) Set the drive select lever to HI position.
(A)
(A) HI position
4) Be sure to insert the cable end bolt into lever arm
slit.
(A) Cable end bolt
(B) Lever arm
CS-36
(B)
CS-00067
CS-00068
(A) (B)
CS-00069